Engine Locator warrants engine parts to be free of defects in materials and workmanship for the warranty period indicated from the date of installation, assuming the part was (and can be documented) installed by a Licensed Automotive Repair Facility.
Gasoline Engines installed in non fleet or commercial Automobiles and Light Trucks up to 11,000 GVW
Years 2000 and Older 3 years, Unlimited mileage, $50 per hour Mitchell labor reimbursement rate - labor paid only on approved claims after factory inspection.
Years 2001 and Newer 5 years, Unlimited mileage, $50 per hour Mitchell labor reimbursement rate - labor paid only on approved claims after factory inspection. Purchases made prior to January 1, 2018 carry warranty of 3 years, Unlimited mileage. First time part replacement is FREE.
Gasoline engines installed in Commercial Fleet Automobiles and Light Trucks
3 years or 75,000 miles, $50 per hour Mitchell labor reimbursement rate - labor paid only on approved claims after factory inspection. First time part replacement is FREE.
Gasoline Engines Medium/Heavy Duty Trucks (Vehicles exceeding 11,000 G.V.W.)
12 months or 12,000 miles, $50 per hour Mitchell labor reimbursement rate - labor paid only on approved claims after factory inspection. First time part replacement is FREE.
Warranty claim reimbursement cannot exceed the total cost of the part purchased.
DIESEL ENGINES
12 months or 12,000 miles, $50 per hour Mitchell labor reimbursement rate - labor paid only on approved claims after factory inspection.
MARINE ENGINES
18 months, unlimited hours, $50 per hour Warranty Labor reimbursement rate with a cap of $800
In the event that it is determined that the part must be replaced, the original part must be returned to remanufacturing facility before any warranty labor consideration and reimbursement.
You must save your proof of purchase receipt. If you’re not able to provide proof of the initial purchase date at the time of warranty service, the manufacturing date of the product will be used to determine the warranty period.
WHAT IS NOT COVERED
Normal Wear: Remanufactured engine products, like all mechanical devices, need periodic parts service and replacement to perform correctly. Our warranty would not apply if damage to the product has occurred because of misuse, lack of routine maintenance, shipping, handling, warehousing or improper installation. Similarly, warranty is void if the serial number of the product has been removed or the product has been altered or modified with aftermarket performance enhancing parts.
IMPROPER MAINTENANCE:
The life of a mechanical device depends upon the conditions under which it operates, and the care it receives. Wear, when caused by dirt, dust, spark plug cleaning grit or other abrasive material that has entered the engine because of improper maintenance, is not covered by warranty.
Our warranty will not extend to cover repairs if:
Problems caused by parts that are not our original (remanufacturer) parts.
Damage as a result of Overheating, Lack of Lubrication, Fuel Wash or Contamination.
Damage resulting from Pre-Ignition or Detonation - Including but not limited to melted or broken piston, broken piston rings, damaged cylinder heads, leaking head gaskets, etc.
Repair or replacement required as a result of any accident or misuse.
Repair or replacement of any accessory or service item, including specifically but not limited to: all components of the cooling, fuel, electrical, exhaust and ignition systems in addition to all belts, hoses, sensors, switches and filters.
Any product used for competition, racing or related purposes.
Any product to which a device or accessory not conforming to original manufacturer’s specifications has been installed.
Damage as a result of electrolysis, including but not limited to, deterioration of engine components as a result of excessive electrical current.
Improperly maintained coolant, and/or any product on which periodic maintenance services required by the original manufacturer have not been performed.
Crankshaft Thrust Surface worn due to excessive forward pressure placed on the rear of the crankshaft.
Damage resulting from improper repair(s) or attempted repair(s) by any service technician.
Leaking carburetors, clogged fuel pipes, sticking valves, or other damage, caused by using contaminated or stale fuel.
Parts which are scored or broken because an engine was operated with insufficient or contaminated lubricating oil or an incorrect grade of lubricating oil (check and refill when necessary, and change at recommended intervals). Engine damage may occur if oil level is not properly maintained.
Repair or adjustment of associated parts or assemblies such as clutches and transmissions.
Damage or wear to parts caused by dirt, which entered the engine because of improper air cleaner maintenance, re-assembly or use of a non-original air cleaner element or cartridge. At recommended intervals, clean and/or replace the filter as stated in the Operator’s Manual.
Engine or equipment parts broken by excessive vibration caused by a loose engine mounting, improper attachment of equipment to engine crankshaft or other abuse in operation.
Lack of routine tune-up or adjustment of the engine.
Engine or engine component failure, i.e., combustion chamber, valves, valve seats, valve guides or burned starter motor windings, caused by the use of alternate fuels such as, liquefied petroleum, natural gas, altered gasoline, etc.
Products used for purposes other than their original intended use.
No warranty shall apply to products installed on any Recreational Vehicles over 11,000 pounds Gross Vehicle Weight which includes most Class A, Class B and Class C Motor Homes and Bus conversions. Additionally, please be aware that the only engines designed expressly for large motor homes should never be used in such an application.
Products used in competitive racing or on commercial or rental race tracks are not warranted. Or remanufactured engine products are not warranted if used in an application for which they were not engineered e.g., using standard gasoline engines in a marine application. This warranty does not apply to fleet or commercial vehicles other than as indicated.
LABOR PAYMENTS
STANDARD WARRANTY:
Authorized repairs on approved claims (after factory inspection of returned parts) will be reimbursed at a rate not to exceed the Mitchell Repair Manual published applicable flat rate schedule. Hourly rates for all authorized repairs will be paid in accordance with rate paid for the original installation but not to exceed $50.00 an hour. Do-it yourself repairs, repairs performed by unlicensed repair facilities, or repairs made to units not originally installed in a LARF will not be reimbursed.
INSTALLATION, BREAK-IN PROCEDURES
Our remanufactured engine products are designed to provide years of trouble-free service. In order for your engine to perform as expected, it must be installed correctly, operated responsibly and properly maintained.
ENGINES AND CYLINDER HEADS
Once the product has been installed, it is the owner’s responsibility to break-in the product properly. After the break-in period and 600 mile checkup, the product must be maintained to the original manufacturer’s specifications.
INITIAL STARTUP
When applicable, valves must be readjusted to your vehicle’s manufacturer’s specifications.
BREAK-IN PROCEDURES
Your remanufactured engine requires special care during its initial “break-in” period. To ensure your engines long life expectancy and proper engine performance, please follow these procedures during the first 600 miles of operation.
Do not drive for long periods at any single speed, always vary your speed.
Do not tow a trailer or put other heavy loads on the vehicle.
Check the engine oil and coolant levels daily.
600 MILE CHECKUP: (NOT COVERED UNDER THE WARRANTY TERMS)
Check fuel and ignition settings.
Change engine oil and filter.
Adjust Valves (where applicable).
Manufacturer does not recommend using synthetic engine oil until after the first 5,000 miles. Follow your vehicle owner’s manual for service intervals.
Failure to perform these procedures can result in damage to the product that will not be covered under your warranty.
Please retain all service records (repair orders, invoices, etc) related to your remanufactured engine product maintenance and service. In the event of a product failure you will be required to provide copies of installation invoice and all maintenance records covering the installed product.Original service records from authorized service center must be kept during warranty period. Personal maintenance records are not accepted. Oil and temperature light/gauge and speedometer MUST be in the proper working order